Step-by-Step Assembly Instructions:Prepare the Tabletops:

• Take the two tabletop halves and place them upside down on a soft surface to prevent scratching.

1. Attach the Table Frame:

   • Attach the frame to the table.

   • Drill holes for the screws (3x30) using a 3mm drill bit, spacing the holes about 15cm apart.

   • Use a screwdriver to enlarge the holes slightly so the screws can be hidden. (Refer to Picture 1)

2. Attach the Middle Frame and Hinges:

   • Attach the middle frame and connect the tabletop halves with hinges.

   • Predrill holes into the frame and use masking tape to hold the hinges in place. (Refer to Picture 2)

   • Use screws (4x30) to secure the hinges.

3. Attach the Legs:

   • Attach the legs using the hinges.

   • Position the legs as indicated on the table, placing them between the two lines. (Refer to Picture 3)

   • Use screws (4x12) to secure the legs.

4. Attach the Middle Hinges:

   • Attach the middle hinges.

   • Use the four crossbars to position the hinges approximately in the middle, and secure them with masking tape. (Refer to Picture 4)

   • Use screws (4x15) to fasten the hinges.

5. Final Assembly:

   • Turn the table on its side and insert the net.

   • Attach the crossbars. (Refer to Picture 5)

6. Finishing Up:

   • Flip the table to its playing position. (Be careful not to put all the weight on one side of the legs when flipping)

1